Skip to Main Content

 

Case Study

KTM Goes Wide Open on Thermal Management of its E-Ride Traction Battery Design


“Regardless of model complexity and size, we can now solve computations of hour-long drive cycles in close to real time, while simpler models can take just minutes. The inclusion of a virtual battery pack also helped our team identify and eliminate potential problems in battery design, including design issues early on in the development process.”

                                                                                                                                          — David Singer Simulation Engineer for Multiphysics / KTM R&D


Introduction

In the spirit of no-trace off-road adventure, KTM, a European motorcycle manufacturer, is focused on taking electrification to the trails with its E-Ride dirt bike. With support from Ansys’ channel partner CADFEM, KTM leveraged Ansys Twin Builder and Ansys Mechanical to develop a simulation workflow and a full 3D model useful in the virtual design, validation, and verification of a traction battery with optimized thermal properties.

Challenges

KTM has a previous history in the solitary use of simulation. An added challenge for the team was creating an entire workflow around battery optimization that used various tools to simultaneously analyze thermal interactions as they relate to thermal hotspot avoidance, temperature distribution, and charging efficiency. KTM needed to be able to use their own code to generate the lookup tables, then used Ansys simulation to tune the parameters and scale up from cells to modules. 

Engineering Solution

An electrical lumped model was used to predict the heat generation per cell as a function of each cell’s temperature and its state of charge (SOC). Resulting values were then fed into a compact thermal model derived from 3D finite element method (FEM) models that calculate the battery’s temperature distribution. A third submodule was then created based on computational fluid dynamics (CFD) analysis to calculate thermal dissipation of the battery housing resulting from convection and radiation. Mechanical was used to create and mesh the high-dimensional FEM model. 

Benefits

  • The KTM team developed a simulation workflow enabled by Twin Builder consisting of three submodules coupled at the system level — all exchanging input and output data during computation. 
  • Twin Builder’s Battery Wizard toolkit was used to generate automatic ECM lookup tables per cell of test data measured and recorded during pulse discharges at various temperatures. The cell ECMs could then be connected in parallel and in series to configure an accurate electrical battery module model. 
  • Parametric tuning for all circuit components enbabled modeling of the instantaneous and dynamic behavior of the cell to better capture the heat generation and output voltage of the cell at different temperatures and states of charge. 
  • Once fully implemented in Twin Builder, the electro-thermal model of the battery pack could simulate real-world drive cycles and predict data outputs, including peak temperatures, temperature distribution, and heat transfer.  
  • System simulations revealed a 20-millivolt single-cell deviation of predicted output voltage and a predicted battery pack model temperature deviation of less than 2 °C, resulting in a stable battery pack design. 

Ansysができること

お問い合わせ

* = 必須項目

お問い合わせいただき、ありがとうございます。

当社はお客様の質問にお答えし、お客様とお話できることを楽しみにしています。Ansysの営業担当が折り返しご連絡いたします。

フッター画像