August 25, 2021
Most computational fluid dynamics (CFD) simulations are solved by generating a hand-crafted mesh with local areas of refinement and coarsening. These refined or coarsened regions make sure there is a fine enough resolution to accurately capture results in important areas but also keep the total cell count manageable.
Although this method is a great way to ensure accuracy, there may be areas where there is too much refinement resulting in longer solve times or too little refinement resulting in less accurate results.
What if there was a method to automatically refine or coarsen the mesh based on the solution to get the most accurate results?
There is, and that is known as adaptive meshing.
Adaptive meshing is a method of refining the mesh of a simulation based on the solution. This scheme in Ansys Fluent enables you to start from a very coarse mesh and dynamically refine high-gradient regions.
Dynamic mesh adaption can be used in combination with the polyhedral unstructured mesh adaption (PUMA) method. PUMA does not rely on any templates for refinement, which does not limit this adaption method to specific element types. A mesh can also be coarsened after it has been refined.
Best practices for combustion and multiphase applications have been embedded in Ansys Fluent’s mesh adaption setup panel in the latest release, Ansys 2021 R2, resulting in:
The Sandia Flame D is a fuel-rich turbulent diffusion methane/air jet flame test case. A pilot flame is injected in between the methane and air inflows. Two tests were done using two different coarse meshes to analyze their accuracy and final cell count difference.
The mesh adaption procedure automatically refined the mesh in critical regions to LES-level meshes, including the reaction zone, shear layer, and recirculation zone. We saw that both cases showed accurate results compared to experimental data.
Fluent’s adaptive meshing solution has shown a varying total cell count reduction of 30-70%, compared to a non-adapted fine LES mesh, across a series of reacting flow cases.
Mesh adaption can also be used to help accurately and efficiently simulate multiphase simulations, like that of a liquid jet breaking up. The volume of fluid (VOF) to discrete phase model (DPM) hybrid multiphase model is used in conjunction with dynamic mesh adaption. The VOF model tracks the liquid-gas interface while the DPM is a separate solver that tracks discrete particles suspended in a Eulerian phase.
The heart of this VOF to DPM model is an algorithm that looks for liquid lumps that get separated from the main liquid body of the spray and then converts them into point masses for further tracking. This method enables us to not track the interface of smaller drops and reduces the need to have very fine meshes.
A second important piece of this hybrid model is the dynamic mesh refinement and coarsening. Interface areas are tracked with fine mesh and once a blob is identified for transfer to the DPM model, the local mesh is coarsened to keep the cell count manageable.
To learn about all of the new enhancements in Fluent’s mesh adaption model, register for the upcoming webinar, Ansys 2021 R2: Ansys Fluent Mesh Adaption Update.
We’re here to answer your questions and look forward to speaking with you. A member of our Ansys sales team will contact you shortly.